Learn How to Reset the Wavlink WiFi Repeater for a Smooth Connection
Experiencing unstable internet or Wi-Fi dead zones? A new Wavlink extender setup might be the solution you need. Unlike traditional boosters, this setup gives you full control over how your extender connects and functions—no WPS required.
If your Wavlink WiFi repeater has been dropping the signal, slowing down, or just refusing to connect properly, a little reset can mostly put things straight. Knowing how to reset Wavlink WiFi repeater would generally ensure that your device performs at its best, without connection failures and configuration errors.
A Wavlink WiFi Extender Reset will wipe out all your previously saved data that includes your network name, password, custom settings, etc. The process will come in handy if you have changed your main router, upgraded the firmware, or simply forgotten the admin password. So it's basically a new start for the repeater, a clean slate.
If you want to do a reset, first of all, it is necessary that you check that your Wavlink repeater is on and properly connected to the power supply. Find the tiny reset button, which is most likely on the back or at the bottom of the device; both the place and the button are usually labeled, and the button is a bit recessed. Take a pin or a paperclip and, by putting it through the hole, press the button for about 10–15 seconds. The LED lights will flash to show that the system has received the command for the reset to start. When the lights get to their normal state, the system has been reset, and the device is back to its original factory settings.
Once you do a Wavlink WiFi repeater reset, the repeater will be disconnected from your home router, so you'll have to set up the connection again. The WPS method is the most convenient one. On your router, press the WPS button, and similarly on your Wavlink repeater, press the WPS button within two minutes. When the indicator lights show that the connection is stable, then wait a bit. If you want to do it manually, you should connect your computer or smartphone to the “Wavlink” SSID, which is the default network, then open a web browser and go to the setup page. Use the default credentials that come with the device and follow the instructions to set up the connection to your WiFi network.
A device restart will not only fix your connection that drops out, but also make the signal strength better and increase the speed. A situation where a device is only partially reset, and thus its performance is improved, is a case of minor glitches and better stability. Moreover, by mastering the proper method of resetting a Wavlink WiFi extender and repeater, you will be able to have a stable and reliable internet network in your home or office without any interruptions.
